[ Chinese wardrobe network ] Does anyone particularly like wooden wardrobes ? The wooden wardrobe sounds very simple. Indeed, the wooden wardrobe gives a very low-key feeling, simple and unpretentious, but it has a special charm that makes it easy for people who like it. I like it, so today we will introduce how to choose wooden wardrobes and how to assemble wooden wardrobes for those who like wooden wardrobes.
Wooden wardrobe
Wooden wardrobe assembly - how to choose wooden wardrobe
1, will press. Lightly press the wardrobe to check the strength of the wardrobe, the support feet are firm, the solid wood wardrobe is stable and full, there will be no feeling of tremor.
2, will see. The solid wood wardrobe has a clear texture and a delicate texture. Carefully identify the texture of the wardrobe, see if the texture inside and outside the wardrobe is consistent, and avoid buying a wardrobe that is only solid wood.
3, will touch. The good wooden wardrobe surface is smooth and delicate, and the paint surface is handled properly, not too thin or too thick.
4, will hear. The wooden wardrobe has the natural aroma of wood, and the synthetic sheet wardrobe has a pungent glue smell, which can be distinguished by careful identification.
Wooden wardrobe assembly - how to assemble wooden wardrobe
1. The general wooden wardrobe assembly is first installed from the end of the wall. The first step is to lay the wide side panel on the ground to see if the hole spacing on the wooden board matches the position on the drawing sheet, and then install it. Single three-in-one single link. Then, the solid layer is nailed to the cork and fixed on the wide side plate, the top handle has a large handle hole facing upward, the other solid layers are facing downward, and the foot line large handle hole faces inward.
2, to nail the backboard, in order to do this in order to better fix the wardrobe and facilitate our operation. First put the assembled whole wardrobe side on our pre-paved cloth, and flatten the side panels of the wooden wardrobe into the same plane. Then measure it with a ruler and measure the diagonal size of our cabinet to equal. Then install the first backboard from the wide side panel. Here we should note that if there is a fixed layer of nails in the middle of our wooden wardrobe, it is best to draw the center line of the fixed layer with a pencil. Stud the nails, and then do a few more steps, so that our wooden wardrobe installation is basically basically formed.
3. Through the above steps, the wardrobe has been basically formed. Then we need to clean the closet to install the wardrobe weaving rack. At this time, we need two people to complete it. We stand on the left and right sides of the closet and lift the closet up slightly. When you push up the position where the wardrobe moves backwards, everyone should pay attention to not scratching our floors and walls. Place the three-in-one rubber pellets into the drawer holes of our closet and connect the side panels on both sides to the drawdown.
4, Finally, our wooden wardrobe installation needs to be installed is the three-section track and the push-pull mirror we often use in daily dressing. When installing these three sections of the track, first place the track against the drawer of the closet, flush the drawer floor, and move the female rail fixing sub-rail screw to the sub-track vertical eye. After the drawer is installed, the adjustable position is used for debugging, so that the drawer surface is flat and the surrounding gap is even. Finally, the fixing screws are placed on the transverse eye of the sub-track and on the vertical eye of the female rail. And so on to install the next one.
The introduction of the wooden wardrobe and the assembly method are introduced here. Because it is introduced very carefully, it is already a very simple thing for people who have good manual skills and strong hands-on ability. If they do not have the ability to do it themselves. If you are confident and want to try it yourself, you may want to look for a professional to guide you next, so you don't have to worry about any problems.
Contour brush. The contour brush is also called the silhouette brush. It is mainly used to modify the outer contour of the face. You can choose a brush with longer bristles and soft touch. Generally, the handle will be slightly longer, a bit like a brush. The brush head has a flat head and a curved head. Common contour brushes:Nose Contour Brush,Contour Brush Nose,Best Contour Brush,Contour Brush Sets,Blend Contour Brush
Nose Contour Brush,Contour Brush Nose,Best Contour Brush,Contour Brush Sets,Blend Contour Brush,Contour Brushes
Shenzhen Nanfang Shishang Cosmetic Utensil Co., Ltd. , https://www.sznfbrush.com