First, Q: print surface single jump paper or print only half
A: This is because the driver has compatibility with some software. Install the TSC TDP-245 compatible driver.
Second, Q: There are printer driver icons in the device and printer, but not in the software.
A: This is because the software shields the printer driver and installs the TSC TDP-245 compatible driver.
Third, Q: When the printer prints a test page, it will be a lot of air.
A: Move the sensor under the paper to the far right (the print head faces itself)
Fourth, Q: the printer only prints half (left and right)
A: Open the print head, press and hold the two sides of the print head, and press down with a little force.
Five, Q: WIFI interface printer, boot red light is long or double flash
A: This phenomenon is normal because the printer is waiting for the device to connect. (Note: Do not hide the information of the printer AP mode when modifying the printer AP mode parameters)
Sixth, Q: When printing a single sheet, occasional jumps
A: This printer data is caused by a problem, reset the threshold (you can move the sensor back and forth before setting it)
7. Q: Out of step (content deviation or shrinking together) when printing content with horizontal lines
A: Modify the drive parameters, the speed is changed to 126MM, the concentration is 6 (can be modified according to the situation)
Acoustic Phone Booths,isolation booth,modular soundproof room,acoustic meeting pods,sound isolation booth
Guangzhou Mingli Intelligent Equipment Co.,Ltd , https://www.minglibooth.com